Rated 5 stars by 80% of reviewers
Rated 4 stars by 16% of reviewers
Rated 3 stars by 3% of reviewers
Rated 2 stars by 1% of reviewers
Rated 1 star by 1% of reviewers
For questions about an order you have placed, please contact customer support directly.
They fit both 7/8 and 1 1/8. The fat bar is only at the mount and tapers to 7/8 at the grip. I would definitely make sure that if you have a twist throttle that you get the mc version and vice versa for atv as the MC version is bigger on the throttle side to fit the twist tube.
jon sYes they'll fit, these are great grips in my opinion. I have them on 2 different bikes and I'll be ordering some for replacements.
Michael HYes the will . they are definitely my favorite grip
MIKE JMy son uses Pro Taper SX 7/8 handlebars and they fit perfectly. They will fit on yours.
Andrew MThe dealer is correct your Husqvarna comes stock with ODI lock on grips which mean that the clutch side is a simple bolt to tighten the grip down and on the throttle side the grip comes attached to the throttle tube. This is installed the same way you would a throttle tube which means that you cannot remove the grip from the throttle tube leaving you with the options of either replacing with a different set of lock ons or buying a standard style throttle tube and then installing the pillow tops like you normally would.
tyler nI've installed several sets old school style. Spray the inside of the grip with hair spray, push and twist them on, align the little pillows so they look good (and removes residual stress in the grip) and wait a few hours, or overnight, for the hairspray to dry. Then they are basically glued on lightly. I do use hand guards, so I cut off the ends and therefore there is no air build up for my installation. Good luck! - CDL
Chris DOf course you can, very simple with a new blade in a utility knife. Just carefully cut a circular hole in the end of each grip(a little larger on the throttle side) and use grip glue, mount your grips, install your bark busters and check for throttle return, let your glue dry. Go ride!
Patrick EYes, grips are pretty much universal with the exception that motorcycle and atv grips will not interchange. Motorcycle grips have one grip oversized to allow for the throttle tube.
Randall PI don't ever recall there being any stickers in the package, but they are awesome grips!
Matt EThey should fit any dirt bike with a twist throttle. Don't buy these for ATVs or bicycles or one will be too big. If you run hand guards, you will need to cut off the ends. I usually cut mine where the colored end meets the black ring.
LAUREN D